HP-SN-MPLS-TC-MIB
- Registered at
- 1.3.6.1.4.1.11.2.3.7.11.12.2.15.15
- Last updated
- 2001-01-04 12:00
- Organization
- Multiprotocol Label Switching (MPLS) Working Group
- Revisions
- 2001-01-04 12:00
- Namespace
- hp
- Source file
HP-SN-MPLS-TC-MIB- Digest
sha256:6192de7186f5e01a3c07b7e4da27b360eb8fc26bd47fa7fdcc40d622a27bdcc4
Description
This MIB module defines Textual Conventions and OBJECT-IDENTITIES for use in documents defining management information bases (MIBs) for managing MPLS networks.
Contact
Thomas D. Nadeau Cisco Systems, Inc. tnadeau@cisco.com Joan Cucchiara Crescent Networks jcucchiara@crescentnetworks.com Cheenu Srinivasan Parama Networks, Inc. cheenu@paramanet.com Arun Viswanathan Force10 Networks, Inc. arun@force10networks.com Hans Sjostrand ipUnplugged hans@ipunplugged.com Email comments to the MPLS WG Mailing List at mpls@uu.net.
Imports
| From | Symbols |
|---|---|
| HP-SN-ROOT-MIB | snMpls |
| SNMPv2-CONF | MODULE-COMPLIANCE, NOTIFICATION-GROUP |
| SNMPv2-SMI | Integer32, MODULE-IDENTITY, NOTIFICATION-TYPE, OBJECT-IDENTITY, OBJECT-TYPE, Unsigned32, iso, transmission |
| SNMPv2-TC | DisplayString, TEXTUAL-CONVENTION |
Imported by
2 module(s) in this corpus import this one.
Load order
Every file a consumer needs in order to load this module, dependencies first.
HP-SN-MPLS-TC-MIB HP-SN-ROOT-MIB SNMPv2-CONF SNMPv2-SMI SNMPv2-TC
Under this module's arcs
Where the registration tree carries on below this module.
| Arc | Name | Module |
|---|---|---|
| 1.3.6.1.4.1.11.2.3.7.11.12.2.15.15.2 | mplsLsrMIB | HP-SN-MPLS-LSR-MIB |
| 1.3.6.1.4.1.11.2.3.7.11.12.2.15.15.3 | mplsTeMIB | HP-SN-MPLS-TE-MIB |
Textual conventions
| Name | OID | Syntax | Access | Status |
|---|---|---|---|---|
| MplsAtmVcIdentifier TEXTUAL-CONVENTION The VCI value for a VCL. The maximum VCI value cannot exceed the value allowable by atmInterfaceMaxVciBits defined in ATM-MIB. The minimum value is 32, values 0 to 31 are reserved for other uses by the ITU and ATM Forum. 32 is typically the default value for the Control VC. | current | |||
| MplsBitRate TEXTUAL-CONVENTION An estimate of bandwidth in units of 1,000 bits per second. If this object reports a value of 'n' then the rate of the object is somewhere in the range of 'n-500' to 'n+499'. For objects which do not vary in bit rate, or for those where no accurate estimation can be made, this object should contain the nominal bit rate. | current | |||
| MplsBurstSize TEXTUAL-CONVENTION The number of octets of MPLS data that the stream may send back-to-back without concern for policing. | current | |||
| MplsExtendedTunnelId TEXTUAL-CONVENTION A unique identifier for an MPLS Tunnel. This MAY represent an IpV4 address of the ingress or egress LSR for the tunnel. This value is derived from the Extended Tunnel Id in RSVP or the Ingress Router ID for CR-LDP. | current | |||
| MplsInitialCreationSource TEXTUAL-CONVENTION The entity that originally created the object in question. The values of this enumeration are defined as follows: other(1) - This is used when an entity which has not been enumerated in this textual convention but which is known by the agent. snmp(2) - The Simple Network Management Protocol was used to configure this object initially. ldp(3 - The Label Distribution Protocol was used to configure this object initially. rsvp(4) - The Resource Reservation Protocol was used to configure this object initially. crldp(5) - The Constraint-Based Label Distribution Protocol was used to configure this object initially. policyAgent(6) - A policy agent (perhaps in combination with one of the above protocols) was used to configure this object initially. unknown(7) - the agent cannot discern which component created the object. | current | |||
| MplsLSPID TEXTUAL-CONVENTION An identifier that is assigned to each LSP and is used to uniquely identify it. This is assigned at the head end of the LSP and can be used by all LSRs to identify this LSP. This value is piggybacked by the signaling protocol when this LSP is signaled within the network. This identifier can then be used at each LSR to identify which labels are being swapped to other labels for this LSP. For IPv4 addresses this results in a 6-octet long cookie. | current | |||
| MplsLabel TEXTUAL-CONVENTION This value represents an MPLS label as defined in [RFC3031], [RFC3032], [RFC3034] and [RFC3035]. | current | |||
| MplsLdpGenAddr TEXTUAL-CONVENTION The value of an network layer or data link layer address. | current | |||
| MplsLdpIdentifier TEXTUAL-CONVENTION The LDP identifier is a six octet quantity which is used to identify an Label Switch Router (LSR) label space. The first four octets identify the LSR and must be a globally unique value, such as a 32-bit router ID assigned to the LSR, and the last two octets identify a specific label space within the LSR. | current | |||
| MplsLdpLabelTypes TEXTUAL-CONVENTION The Layer 2 label types which are defined for MPLS LDP/CRLDP are generic(1), atm(2), or frameRelay(3). | current | |||
| MplsLsrIdentifier TEXTUAL-CONVENTION The Label Switch Router (LSR) identifier is the first 4 bytes of the Label Distribution Protocol (LDP) identifier. | current | |||
| MplsPathIndex TEXTUAL-CONVENTION A unique identifier used to identify a specific path used by a tunnel. | current | |||
| MplsPathIndexOrZero TEXTUAL-CONVENTION A unique identifier used to identify a specific path used by a tunnel. If this value is set to 0, it indicates that no path is in use. | current | |||
| MplsPortNumber TEXTUAL-CONVENTION A TCP or UDP port number. Along with an IP address identifies a stream of IP traffic uniquely. | current | |||
| MplsTunnelAffinity TEXTUAL-CONVENTION Include-any, include-all, or exclude-all constraint for link selection. | current | |||
| MplsTunnelIndex TEXTUAL-CONVENTION Index into mplsTunnelTable. | current | |||
| MplsTunnelInstanceIndex TEXTUAL-CONVENTION Instance index into mplsTunnelTable. | current |
Objects
| Name | OID | Syntax | Access | Status |
|---|---|---|---|---|
| mplsMIB OBJECT-IDENTITY | 1.3.6.1.4.1.11.2.3.7.11.12.2.15.15 |