CADANT-TC

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the type of AAA methods available on the C4.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the different types of accounting services.

TEXTUAL-CONVENTION

The administrative or the desired states of the element and are set by the EMS.

TEXTUAL-CONVENTION

The name of the ACL this ACE is part of.

TEXTUAL-CONVENTION

The type of ACL this ACE is part of.

TEXTUAL-CONVENTION

Uniquely identifies the bridge group.

TEXTUAL-CONVENTION

Type of traffic allowed on a bridge port. Ethernet ports allow any type of traffic. RF ports can be sub divided for CM traffic, authorized CPE traffic, and unauthorized CPE traffic.

TEXTUAL-CONVENTION

CPE Device types.

TEXTUAL-CONVENTION

This type is used to express and display 64-bit, double-precision floating-point values.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the condition of Extended ACLs.

TEXTUAL-CONVENTION

A direction of flow on an interface.

TEXTUAL-CONVENTION

The port of an IP packet. The value -1 indicates that this field is not used.

TEXTUAL-CONVENTION

The type-of-service of an IP packet. The value 0 indicates that this field is not used.

TEXTUAL-CONVENTION

The allowed type-of-service mask of an IP packet. 30 is used when the 4 bit TOS is specified. 224 is used when the 3 bit precedence is specified, and 254 is used when the entire 7 bit TOS is specified. A value of 0 indicates that the TOS field is not used.

TEXTUAL-CONVENTION

The protocol type an IP packet (8 bits). 0 is IP, 1 is ICMP, 2 is IGMP, 6 is TCP 17 is UDP. See RFC-1700 for complete list. The value -1 indicates an invalid/unused protocol type.

TEXTUAL-CONVENTION

The values available in the flags portion of the TCP header.

TEXTUAL-CONVENTION

Uniquely identifies the individual Circuit Pack. Number of 99 indicates an invalid CardId.

TEXTUAL-CONVENTION

Uniquely identifies an entity on the circuit pack.

TEXTUAL-CONVENTION

Enumeration of more specific current Card Type. For cards with only one subtype, the type and subtype should be identical.

TEXTUAL-CONVENTION

Enumeration of generic Card Type.

TEXTUAL-CONVENTION

Describe the disk volume usage level

TEXTUAL-CONVENTION

not applicable to all components

TEXTUAL-CONVENTION

not applicable to all components

TEXTUAL-CONVENTION

This type describes the initial source of the firmware running on a card. Committed and transient indicate the card flash device and the downloaded image, respectively. Boot1 and Boot2 indicate which of the resident boot images was used to boot the card.

TEXTUAL-CONVENTION

Flow Activity State describes the recent bandwidth utilization history of a service flow relative to its Service Level Agreement. A flow that is operating below its Tmin is said to be 'needy'. A flow that is operating above Tmin but below Tmid is said to be 'normal'. A flow that is operating above Tmid but below Tmax is said to be 'greedy'.

TEXTUAL-CONVENTION

flow control settings for a network port.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION is similar to InetAddress as defined in the INET-ADDRESS-MIB. However, InetAddressIPv4or6 does not allow DNS addresses and its address type, either IPv4 or IPv6, can be readily determined from its length alone. If the address is an IPv4 address, then the length will be exactly 4 bytes. If the address is an IPv6 address, then the length will be either 16 or 20 bytes. If the length if 0, then the address is empty or null. If the length is 4: octets contents encoding 1-4 IP address network-byte order If the length is 8: octets contents encoding 1-8 EUI IPv6 address network-byte order If the length is 16: octets contents encoding 1-16 IPv6 address network-byte order If the length is 20: octets contents encoding 1-16 IPv6 address network-byte order 17-20 scope identifier network-byte order The scope identifier (bytes 17-20) MUST NOT be present for global IPv6 addresses. For non-global IPv6 addresses (e.g. link-local or site-local addresses), the scope identifier MUST always be present. It contains a link identifier for link-local and a site identifier for site-local IPv6 addresses. The scope identifier MUST disambiguate identical address values. For link-local addresses, the scope identifier will typically be the interface index (ifIndex as defined in the IF-MIB, RFC 2233) of the interface on which the address is configured. The scope identifier may contain the special value 0 which refers to the default scope. The default scope may be used in cases where the valid scope identifier is not known (e.g., a management application needs to write a site-local InetAddressIPv6 address without knowing the site identifier value). The default scope SHOULD NOT be used as an easy way out in cases where the scope identifier for a non-global IPv6 is known.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the type line connections available on the C4.

TEXTUAL-CONVENTION

Enumeration of current Port Type.

TEXTUAL-CONVENTION

A valid unique identifier for a MAC port in a C4 CMTS system.

TEXTUAL-CONVENTION

Identifier for a MAC port in a C4 CMTS system.

TEXTUAL-CONVENTION

Represents the first three(3), most significant bytes of an 802 MAC address represented in the `canonical' order defined by IEEE 802.1a, i.e., as if it were transmitted least significant bit first, even though 802.5 (in contrast to other 802.x protocols) requires MAC addresses to be transmitted most significant bit first.

TEXTUAL-CONVENTION

Three levels indicating how much work the card is doing.

TEXTUAL-CONVENTION

This type describes the PIC attached to the backplane behind a a card.

TEXTUAL-CONVENTION

detected mode settings for a network port.

TEXTUAL-CONVENTION

Uniquely identifies the port. Number of 99 indicates an invalid PortId.

TEXTUAL-CONVENTION

mode settings for a network port.

TEXTUAL-CONVENTION

Enumeration of current Port Type.

TEXTUAL-CONVENTION

The operational state IS(1): The element is operable and available for use OOS(2): The element/resource is inoperable and unable to provide service UNEQ(3): The element/resource is unequiped.

TEXTUAL-CONVENTION

The set of days in a month on which a scheduled action should take place. There are two sets of bits one can use to define the day within a month: Enumerations starting with the letter 'd' indicate a day in a month relative to the first day of a month. The first day of the month can therefore be specified by setting the bit d1(0) and d31(30) means the last day of a month with 31 days. Enumerations starting with the letter 'r' indicate a day in a month in reverse order, relative to the last day of a month. The last day in the month can therefore be specified by setting the bit r1(31) and r31(61) means the first day of a month with 31 days. Setting multiple bits will include several days in the set of possible days for this schedule. Setting all bits will cause the scheduler to ignore the day within a month. Setting all bits starting with the letter 'd' or the letter 'r' will also cause the scheduler to ignore the day within a month.

TEXTUAL-CONVENTION

The set of hours within a day during which the scheduled action should take place.

TEXTUAL-CONVENTION

The set of minutes within an hour when the scheduled action should take place.

TEXTUAL-CONVENTION

The set of months during which the scheduled action should take place. Setting multiple bits will include several months in the set of possible months for this schedule. Setting all bits will cause the scheduler to ignore the month.

TEXTUAL-CONVENTION

The set of weekdays on which the scheduled action should take place. Setting multiple bits will include several weekdays in the set of possible weekdays for this schedule. Setting all bits will cause the scheduler to ignore the weekday.

TEXTUAL-CONVENTION

For each PrimaryState, there might be an associated secondary state

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the INET services available on the SCM.

TEXTUAL-CONVENTION

Uniquely identifies the shelf. Number of 99 indicate an invalid ShelfId.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the authentication method available in SSH on the C4.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the ciphers available in SSH on the C4.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the specific cipher type on the C4.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the MAC algorithm available in SSH on the C4.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the SSH protocol versions available in SSH on the C4.

TEXTUAL-CONVENTION

This TEXTUAL-CONVENTION describes the SSH service types available in SSH on the C4.

TEXTUAL-CONVENTION

Similar to TMN representation of the Unknown Status.

TEXTUAL-CONVENTION

The unique identifier for a Virtual LAN. A value of 1000000 indicates unknown VLAN.