MIBs Depot

MITEL-NAT-MIB

Registered at
1.3.6.1.4.1.1027.4.8.1.1.2
Last updated
2003-03-24 10:01
Organization
MITEL Corporation
Revisions
2003-03-24 10:01, 1999-03-01 00:00
Namespace
mitel
Source file
MITEL-NAT-MIB
Digest
sha256:d277b2eb185f3a8c57cb67364608686071b45ee89657d75434bd864aef313c8d

Description

The MITEL IP MIB module.

Contact

Standards Group, Postal: MITEL Corporation 350 Legget Drive, PO Box 13089 Kanata, Ontario Canada K2K 1X3 Tel: +1 613 592 2122 Fax: +1 613 592 4784 E-mail: std@mitel.com

Imports

FromSymbols
SNMPv2-CONFMODULE-COMPLIANCE, NOTIFICATION-GROUP
SNMPv2-SMIInteger32, IpAddress, MODULE-IDENTITY, NOTIFICATION-TYPE, OBJECT-IDENTITY, OBJECT-TYPE, enterprises, iso
SNMPv2-TCDisplayString, RowStatus, TEXTUAL-CONVENTION

Imported by

Nothing in this corpus imports this module.

Load order

Every file a consumer needs in order to load this module, dependencies first.

MITEL-NAT-MIB
SNMPv2-CONF
SNMPv2-SMI
SNMPv2-TC

Objects

NameOIDSyntaxAccessStatus
mitel
OBJECT-IDENTITY
1.3.6.1.4.1.1027
mitelProprietary
OBJECT-IDENTITY
1.3.6.1.4.1.1027.4
mitelPropIpNetworking
OBJECT-IDENTITY
1.3.6.1.4.1.1027.4.8
mitelIpNetRouter
OBJECT-IDENTITY
1.3.6.1.4.1.1027.4.8.1
mitelRouterIpGroup
OBJECT-IDENTITY
1.3.6.1.4.1.1027.4.8.1.1
mitelNatGrpIfTable
OBJECT-TYPE
The IP network address translation configuration table.
1.3.6.1.4.1.1027.4.8.1.1.2.1not-accessiblecurrent
mitelNatGrpIfEntry
OBJECT-TYPE
Contains information about network address translation on a single IP interface.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1not-accessiblecurrent
mitelNatGrpIfAddr
OBJECT-TYPE
The IP address of the interface.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.1IpAddressread-onlycurrent
mitelNatGrpIfEnable
OBJECT-TYPE
Configures the router to enable IP NAT on a virtual interface.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.2INTEGER {enabled(1), disabled(2)}read-writecurrent
mitelNatGrpIfUdpLifetime
OBJECT-TYPE
Specifies timeout in seconds for a NAT UDP session.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.3Integer32read-writecurrent
mitelNatGrpIfTcpLifetime
OBJECT-TYPE
Specifies timeout in seconds for a NAT TCP session.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.4Integer32read-writecurrent
mitelNatGrpIfTcpFinLifetime
OBJECT-TYPE
Specifies timeout in seconds for a NAT TCP session once a FIN was seen.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.5Integer32read-writecurrent
mitelNatGrpIfTcpRstLifetime
OBJECT-TYPE
Specifies timeout in seconds for a NAT TCP session once a RST was seen.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.6Integer32read-writecurrent
mitelNatGrpIfPingLifetime
OBJECT-TYPE
Specifies timeout in seconds for an ICMP echo.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.7Integer32read-writecurrent
mitelNatGrpIfStatus
OBJECT-TYPE
The current status of this entry.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.8RowStatusread-createcurrent
mitelNatGrpIfIndex
OBJECT-TYPE
The current Interface this entry pertains to.
1.3.6.1.4.1.1027.4.8.1.1.2.1.1.9Integer32read-onlycurrent
mitelNatGrpRedirTable
OBJECT-TYPE
The IP network address translation redirection table.
1.3.6.1.4.1.1027.4.8.1.1.2.2not-accessiblecurrent
mitelNatGrpRedirEntry
OBJECT-TYPE
Contains information about network address translation incoming on a single IP interface.
1.3.6.1.4.1.1027.4.8.1.1.2.2.1not-accessiblecurrent
mitelNatGrpRedirOldAddr
OBJECT-TYPE
The IP address of the interface.
1.3.6.1.4.1.1027.4.8.1.1.2.2.1.1IpAddressread-onlycurrent
mitelNatGrpRedirProto
OBJECT-TYPE
Identifies the IP protocol to redirect, 6 or 17.
1.3.6.1.4.1.1027.4.8.1.1.2.2.1.2Integer32read-onlycurrent
mitelNatGrpRedirOldPort
OBJECT-TYPE
Identifies the TCP or UDP port to redirect.
1.3.6.1.4.1.1027.4.8.1.1.2.2.1.3Integer32read-onlycurrent
mitelNatGrpRedirNewAddr
OBJECT-TYPE
The IP address to which the datagram is to be redirected. Default is 0.0.0.0
1.3.6.1.4.1.1027.4.8.1.1.2.2.1.4IpAddressread-writecurrent
mitelNatGrpRedirNewPort
OBJECT-TYPE
The TCP or UDP port to which the datagram is to be redirected.
1.3.6.1.4.1.1027.4.8.1.1.2.2.1.5Integer32read-writecurrent
mitelNatGrpRedirStatus
OBJECT-TYPE
The current status of this entry.
1.3.6.1.4.1.1027.4.8.1.1.2.2.1.6RowStatusread-createcurrent