MIBs Depot

CISCO-ETHERLIKE-EXT-MIB

Registered at
1.3.6.1.4.1.9.9.645
Last updated
2010-06-04 00:00
Organization
Cisco Systems, Inc.
Revisions
2010-06-04 00:00, 2008-10-15 00:00, 2008-01-09 00:00
Namespace
cisco
Source file
CISCO-ETHERLIKE-EXT-MIB
Digest
sha256:5306c99a91e5840090e1c12acf7012b4ebbc25345aa412a2e6aef34c855a244d

Description

The MIB module to describe generic objects for ethernet-like network interfaces. This MIB provides ethernet-like network interfaces information that are either excluded by EtherLike-MIB or specific to Cisco products.

Contact

Cisco Systems Customer Service Postal: 170 W Tasman Drive San Jose, CA 95134 USA Tel: +1 800 553-NETS E-mail: cs-lan-switch-snmp@cisco.com

Imports

FromSymbols
CISCO-SMIciscoMgmt
EtherLike-MIBdot3StatsIndex
IF-MIBifIndex
SNMPv2-CONFMODULE-COMPLIANCE, NOTIFICATION-GROUP, OBJECT-GROUP
SNMPv2-SMIMODULE-IDENTITY, NOTIFICATION-TYPE, OBJECT-IDENTITY, OBJECT-TYPE, Unsigned32, iso
SNMPv2-TCDisplayString, TEXTUAL-CONVENTION

Imported by

Nothing in this corpus imports this module.

Load order

Every file a consumer needs in order to load this module, dependencies first.

CISCO-ETHERLIKE-EXT-MIB
CISCO-SMI
EtherLike-MIB
IANAifType-MIB
IF-MIB
SNMPv2-CONF
SNMPv2-MIB
SNMPv2-SMI
SNMPv2-TC

Objects

NameOIDSyntaxAccessStatus
ciscoEtherExtMIBNotifs
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.645.0
ciscoEtherExtMIBObjects
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.645.1
ceeDot3PauseExt
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.645.1.1
ceeDot3PauseExtTable
OBJECT-TYPE
A list of additional descriptive and status information about the MAC Control PAUSE function on the ethernet-like interfaces attached to a particular system, in extension to dot3PauseTable in EtherLike-MIB. There will be one row in this table for each ethernet-like interface in the system which supports the MAC Control PAUSE function.
1.3.6.1.4.1.9.9.645.1.1.1not-accessiblecurrent
ceeDot3PauseExtEntry
OBJECT-TYPE
An entry in the table, containing additional information about the MAC Control PAUSE function on a single ethernet-like interface, in extension to dot3PauseEntry in Etherlike-MIB.
1.3.6.1.4.1.9.9.645.1.1.1.1not-accessiblecurrent
ceeDot3PauseExtAdminMode
OBJECT-TYPE
Indicates preference to send or process pause frames on this interface. txDesired(0) - indicates preference to send pause frames, but autonegotiates flow control. This bit can only be turned on when the corresponding instance of dot3PauseAdminMode has the value of 'enabledXmit' or 'enabledXmitAndRcv'. rxDesired(1) - indicates preference to process pause frames, but autonegotiates flow control. This bit can only be turned on when the corresponding instance of dot3PauseAdminMode has the value of 'enabledRcv' or 'enabledXmitAndRcv'.
1.3.6.1.4.1.9.9.645.1.1.1.1.1Bits {txDesired(0), rxDesired(1)}read-writecurrent
ceeDot3PauseExtOperMode
OBJECT-TYPE
Provides additional information about the flow control operational status on this interface. txDisagree(0) - the transmit pause function on this interface is disabled due to disagreement from the far end on negotiation. rxDisagree(1) - the receive pause function on this interface is disabled due to disagreement from the far end on negotiation. txDesired(2) - the transmit pause function on this interface is desired. rxDesired(3) - the receive pause function on this interface is desired.
1.3.6.1.4.1.9.9.645.1.1.1.1.2Bits {txDisagree(0), rxDisagree(1), txDesired(2), rxDesired(3)}read-onlycurrent
ceeSubIf
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.645.1.2
ceeSubInterfaceTable
OBJECT-TYPE
This table provides the subinterface related information associated to the Ethernet-like interfaces. The subinterface is a division of one physical interface into multiple logical interfaces. As an example of what a typical subinterface setup might look like on a device, a single Ethernet port such as GigabitEthernet0/0 would be subdivided into Gi0/0.1, Gi0/0.2, Gi0/0.3 and so on, each one performing as if it were a separate interface.
1.3.6.1.4.1.9.9.645.1.2.1not-accessiblecurrent
ceeSubInterfaceEntry
OBJECT-TYPE
This table contains a row for each Ethernet-like interface by it's ifTable ifIndex in the system, which supports the sub-interface. An entry is created by an agent, when it detects a Ethernet-like interface is created in ifTable and it can support sub-interface. An entry is deleted by an agent, when the ifTable entry associated to the Ethernet-like interface is deleted. Typically, when the card is removed from the device.
1.3.6.1.4.1.9.9.645.1.2.1.1not-accessiblecurrent
ceeSubInterfaceCount
OBJECT-TYPE
This object represents the number of subinterfaces created on a Ethernet-like interface.
1.3.6.1.4.1.9.9.645.1.2.1.1.1Unsigned32 (0..4294967295)read-onlycurrent
ciscoEtherExtMIBConform
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.645.2
ceeEtherExtMIBCompliances
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.645.2.1
ceeEtherExtMIBGroups
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.645.2.2

Conformance

NameOIDStatus
ceeEtherExtMIBCompliance
MODULE-COMPLIANCE
The compliance statement for CISCO-ETHERLIKE-EXT-MIB.
1.3.6.1.4.1.9.9.645.2.1.1deprecated
ceeEtherExtMIBComplianceR01
MODULE-COMPLIANCE
The compliance statement for CISCO-ETHERLIKE-EXT-MIB. This deprecates ceeEtherExtMIBCompliance.
1.3.6.1.4.1.9.9.645.2.1.2current
ciscoEtherExtPauseGroup
OBJECT-GROUP
A collection of objects providing the additional information for the control of the MAC Control PAUSE function on ethernet-like network interfaces.
1.3.6.1.4.1.9.9.645.2.2.1current
ciscoEtherExtSubIfGroup
OBJECT-GROUP
A collection of objects providing the Ethernet-like subinterface information.
1.3.6.1.4.1.9.9.645.2.2.2current