MIBs Depot

CISCO-BRIDGE-EXT-MIB

Registered at
1.3.6.1.4.1.9.9.401
Last updated
2008-05-22 00:00
Organization
Cisco Systems, Inc.
Revisions
2008-05-22 00:00, 2005-04-07 00:00, 2004-12-03 00:00, 2004-08-23 00:00
Namespace
cisco
Source file
CISCO-BRIDGE-EXT-MIB
Digest
sha256:45b1017e198bcdeb9604c659e50998df19cb55357c5a0a4411886b057eada29e

Description

A MIB module for extending BRIDGE-MIB specified in RFC 1493.

Contact

Cisco Systems Customer Service Postal: 170 W Tasman Drive San Jose, CA 95134 USA Tel: +1 800 553-NETS E-mail: cs-lan-switch-snmp@cisco.com

Imports

FromSymbols
BRIDGE-MIBdot1dBasePort
CISCO-SMIciscoMgmt
CISCO-TCCiscoPortList, CiscoPortListRange
Q-BRIDGE-MIBVlanId, VlanIndex
SNMPv2-CONFMODULE-COMPLIANCE, NOTIFICATION-GROUP, OBJECT-GROUP
SNMPv2-SMIInteger32, MODULE-IDENTITY, NOTIFICATION-TYPE, OBJECT-IDENTITY, OBJECT-TYPE, Unsigned32, iso
SNMPv2-TCDisplayString, MacAddress, RowStatus, TEXTUAL-CONVENTION, TruthValue

Imported by

Nothing in this corpus imports this module.

Load order

Every file a consumer needs in order to load this module, dependencies first.

BRIDGE-MIB
CISCO-BRIDGE-EXT-MIB
CISCO-SMI
CISCO-TC
IANAifType-MIB
IF-MIB
P-BRIDGE-MIB
Q-BRIDGE-MIB
RFC1158-MIB
RFC1271-MIB
RMON-MIB
RMON2-MIB
SNMP-FRAMEWORK-MIB
SNMPv2-CONF
SNMPv2-MIB
SNMPv2-SMI
SNMPv2-TC
TOKEN-RING-RMON-MIB

Objects

NameOIDSyntaxAccessStatus
cbExtMIBNotifications
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.401.0
cbExtMIBObjects
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.401.1
cbeDot1dTp
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.401.1.1
cbeDot1dTpGlobalAgingTime
OBJECT-TYPE
The timeout period in seconds for aging out dynamically learned forwarding information at the device level. Setting this object value to zero will disable the aging out action globally except at the VLANs where cbeDot1dTpVlanAgingTime is configured. 802.1D-1990 recommends a default of 300 seconds.
1.3.6.1.4.1.9.9.401.1.1.1Unsigned32 (0 | 10..1000000)read-writecurrent
cbeDot1dTpVlanTable
OBJECT-TYPE
This table provides the configuration for aging out dynamically learned forwarding information at each VLAN. This table is populated for each existing VLAN in the device as well as non-existing VLANs which have the aging out value configured.
1.3.6.1.4.1.9.9.401.1.1.2not-accessiblecurrent
cbeDot1dTpVlanEntry
OBJECT-TYPE
Each entry contains the aging out configuration and the configuration source of the aging out value applied at each VLAN.
1.3.6.1.4.1.9.9.401.1.1.2.1not-accessiblecurrent
cbeDot1dTpVlanIndex
OBJECT-TYPE
Indicates the VLAN number.
1.3.6.1.4.1.9.9.401.1.1.2.1.1VlanIndexnot-accessiblecurrent
cbeDot1dTpVlanAgingTime
OBJECT-TYPE
The timeout period in seconds for aging out dynamically learned forwarding information at this VLAN. Setting this object value to zero will disable the aging out action for this VLAN. 802.1D-1990 recommends a default of 300 seconds. This object provides the same functionality as dot1dTpAgingTime object in BRIDGE-MIB with one exception that setting this object value to zero will disable the aging out action for this VLAN.
1.3.6.1.4.1.9.9.401.1.1.2.1.2Unsigned32 (0 | 10..1000000)read-createcurrent
cbeDot1dTpVlanAgingFromGlobal
OBJECT-TYPE
Indicates whether the aging time applied at this VLAN is from cbeDot1dTpGlobalAgingTime object or not. true(1) indicates the aging time applied at this VLAN is from cbeDot1dTpGlobalAgingTime object. When true(1) is configured, value of cbeDot1dTpVlanAgingTime object in the same row will have the same value as cbeDot1dTpGlobalAgingTime object. false(2) indicates the aging time applied at this VLAN is from cbeDot1dTpVlanAgingTime object. If users configure cbeDot1dTpVlanAgingTime object in the same row while this object value is true(1), this object value will be changed to false(2) to reflect that the aging time applied at this VLAN is not from cbeDot1dTpGlobalAgingTime object.
1.3.6.1.4.1.9.9.401.1.1.2.1.3TruthValueread-createcurrent
cbeDot1dTpVlanRowStatus
OBJECT-TYPE
The status of this conceptual row entry. This object is used to manage creation and deletion of rows in this table. To create an entry, users set the value of this object to createAndGo(4). To delete an entry, users set the value of this object to destroy(6). Deletion of an entry in this table is only allowed if the VLAN indicated by its row index object does not exist in the device. cbeDot1dTpVlanAgingTime and cbeDot1dTpVlanAgingFromGlobal can be modified at any time (even while the row is active). If users set the value of cbeDot1dTpVlanAgingFromGlobal object to true(1) and the VLAN indicated by cbeDot1dTpVlanIndex object in the same row does not exist, the entry will be removed from this table.
1.3.6.1.4.1.9.9.401.1.1.2.1.4RowStatusread-createcurrent
cbeDot1dStatic
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.401.1.2
cbeDot1dStaticTable
OBJECT-TYPE
A table containing filtering information configured into the device by (local or network) management to specify the set of bridge ports within a specific range of bridge port number for a specific VLAN, to which frames received from specific ports and containing specific destination addresses are allowed to be forwarded. The value of zero in this table as the port number from which frames with a specific destination address are received, is used to specify all ports for which there is no specific entry in this table for that particular destination address. Entries are valid for unicast and for group/broadcast addresses.
1.3.6.1.4.1.9.9.401.1.2.1not-accessiblecurrent
cbeDot1dStaticEntry
OBJECT-TYPE
Each entry represents filtering information configured into the device by (local or network) management specifying the set of bridge ports within a specific range of bridge port number for a specific VLAN, to which frames received from a specific port and containing a specific destination address are allowed to be forwarded.
1.3.6.1.4.1.9.9.401.1.2.1.1not-accessiblecurrent
cbeDot1dVlanIndex
OBJECT-TYPE
The VLAN ID of a specific VLAN.
1.3.6.1.4.1.9.9.401.1.2.1.1.1VlanIndexnot-accessiblecurrent
cbeDot1dStaticAddress
OBJECT-TYPE
The destination MAC address in a frame to which this entry's filtering information applies. This object can take the value of a unicast address, a group address or the broadcast address.
1.3.6.1.4.1.9.9.401.1.2.1.1.2MacAddressnot-accessiblecurrent
cbeDot1dStaticReceivePort
OBJECT-TYPE
Either the value '0', or the port number of the port from which a frame must be received in order for this entry's filtering information to apply. A value of zero indicates that this entry applies on all ports of the bridge for which there is no other applicable entry.
1.3.6.1.4.1.9.9.401.1.2.1.1.3Integer32 (0..65535)not-accessiblecurrent
cbeDot1dStaticPortRangeIndex
OBJECT-TYPE
The index that uniquely identifies a particular range of bridge port number.
1.3.6.1.4.1.9.9.401.1.2.1.1.4CiscoPortListRangenot-accessiblecurrent
cbeDot1dStaticAllowedToGoTo
OBJECT-TYPE
A set of ports in a specific VLAN, in a specific range of bridge port number, to which frames received from a specific port, destined for a specific MAC address are allowed to be forwarded. An entry in this table with the index value of cbeDot1dStaticPortRangeIndex being 'oneto2K' and instance value of the corresponding cbeDot1dStaticAllowedToGoTo being zero-length octet string indicates that frames received in the VLAN as specified by this entry's cbeDot1dVlanIndex, from a port as specified by this entry's cbeDot1dStaticReceivePort, and destined to the MAC address as specified by this entry's cbeDot1dStaticAddress, are not allowed to be forwarded to any of the ports in this VLAN.
1.3.6.1.4.1.9.9.401.1.2.1.1.5CiscoPortListread-writecurrent
cbeDot1dStaticStatus
OBJECT-TYPE
This object indicates the status of this entry. other(1) - this entry is currently in use but the conditions under which it will remain so differ from the following values. invalid(2) - writing this value to the object removes the corresponding entry. permanent(3) - this entry is currently in use and will remain so after the next reset of the bridge. deleteOnReset(4) - this entry is currently in use and will remain so until the next reset of the bridge. deleteOnTimeout(5) - this entry is currently in use and will remain so until it is aged out.
1.3.6.1.4.1.9.9.401.1.2.1.1.6INTEGER {other(1), invalid(2), permanent(3), deleteOnReset(4), deleteOnTimeout(5)}read-writecurrent
cbeDot1dVlan
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.401.1.3
cbeDot1dVlanTable
OBJECT-TYPE
A list of 802.1D access ports. Every access port that is currently associated with a bridge has a corresponding entry in this table.
1.3.6.1.4.1.9.9.401.1.3.1not-accessiblecurrent
cbeDot1dVlanEntry
OBJECT-TYPE
An entry containing VLAN information for a particular 802.1D access port.
1.3.6.1.4.1.9.9.401.1.3.1.1not-accessiblecurrent
cbeDot1dVlanOperVlan
OBJECT-TYPE
The VLAN-ID of the VLAN with which the access port is currently associated.
1.3.6.1.4.1.9.9.401.1.3.1.1.1VlanIdread-onlycurrent
cbExtMIBConformance
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.401.2
cbExtMIBCompliances
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.401.2.1
cbExtMIBGroups
OBJECT-IDENTITY
1.3.6.1.4.1.9.9.401.2.2

Conformance

NameOIDStatus
cbExtMIBCompliance
MODULE-COMPLIANCE
The compliance statement for CISCO-BRIDGE-EXT-MIB.
1.3.6.1.4.1.9.9.401.2.1.1deprecated
cbExtMIBCompliance2
MODULE-COMPLIANCE
The compliance statement for CISCO-BRIDGE-EXT-MIB.
1.3.6.1.4.1.9.9.401.2.1.2deprecated
cbExtMIBCompliance3
MODULE-COMPLIANCE
The compliance statement for CISCO-BRIDGE-EXT-MIB.
1.3.6.1.4.1.9.9.401.2.1.3current
cbeDot1dTpGroup
OBJECT-GROUP
A collection of objects providing timeout period for aging out of dynamically learned forwarding information at the device level.
1.3.6.1.4.1.9.9.401.2.2.1current
cbeDot1dTpVlanGroup
OBJECT-GROUP
A collection of objects providing timeout period for aging out of dynamically learned forwarding information at each VLAN.
1.3.6.1.4.1.9.9.401.2.2.2current
cbeDot1dStaticGroup
OBJECT-GROUP
A collection of objects for configuration of static filtering information.
1.3.6.1.4.1.9.9.401.2.2.3current
cbeDot1dOperVlanGroup
OBJECT-GROUP
A collection of objects to show the operational VLAN information on bridge ports.
1.3.6.1.4.1.9.9.401.2.2.4current